DSR-EZ quickstart procedure:
(for reef tanks without structural problems)

First walk through the “high nutrients topic”!

• Install power filter (remove as much detritus as possible from sandbed)
• Install and calibrate auto dosing units.
• Always place the outflux higher than the EZ bottles, to prevent overdosing by syphoning.
• Place outflux above water and  use oneway valves to prevent liquid from flowing back into the bottle.
• measure KH, Ca, Mg, PO4,NO3 to get insight of your parameters and  start baseline dosing when neccesary.
• use these testkits and the DSR reference to verify them.
• Start the baseline dosing for EZCarbon (mentioned on container)
• Start the baseline dosing for EZBuffer (mentioned on container)
• Start the baseline dosing for EZCalcium (mentioned on container)
• Start the baseline dosing for EZTrace (50% of EZCalcium dosing)
• Do (bi)weekly measurements and top up if necessary.
• Finetine  dosing to keep parameter steady

When starting DSR on a  system with very high PO4/NO3 make sure to siphon the sandbed, use a powerfilter and walk through the above mentioned high nutrients topic to prevent bacteria bloom.